Pilot Light Won’t Stay Lit on Gas Water Heater – Here’s What To Do

Most modern gas water heaters have a pilot light that ignites the burner. If your pilot light won’t stay lit, it could be caused by something as simple as a dirty flame sensor. The good news is that this is an easy problem to fix yourself. First, make sure that the pilot light tube is clear of any debris. Then, remove the flame sensor and clean it with a wire brush.

Once you’ve done that, reattach the flame sensor and turn on the gas. If the pilot light still won’t stay lit, you may need to adjust the gas pressure or replace the thermocouple. If you’re not comfortable doing this yourself, you can always call a plumber for help.

If the pilot light will not stay lit on your gas water heater, follow these simple steps to relight it

Many gas water heaters have a pilot light that ignites the burner. If the pilot light goes out, you will not have any hot water. Luckily, it is usually easy to relight the pilot light. First, locate the pilot light assembly on the side of the water heater. Then, turn off the gas supply by turning the knob to the “off” position. Next, use a long lighter or a match to ignite the pilot light.

Once the flame is lit, turn on the gas supply by slowly turning the knob to the “on” position. Finally, check all of the connections to make sure they are tight. By following these simple steps, you should be able to relight your pilot light and get your hot water flowing again.

Why does my pilot light keep going out

There are a few reasons why your pilot light might keep going out. One possibility is that there is a draft coming from somewhere and blowing out the flame. Another possibility is that the flame sensor needs to be cleaned. Yet another possibility is that the gas pressure is too low. If you’re not sure what’s causing the problem, it’s best to call a plumber for help.

Make sure you have a safe place to work on the water heater – preferably in an open area with good ventilation

Before you begin any work on the water heater, it is important to make sure that you have a safe and suitable workspace. The area should be well ventilated, preferably in an open area such as a garage or workshop. There should also be no naked flames or other sources of ignition present. Once you have prepared your workspace, the next step is to disconnect the power supply to the water heater.

This can be done by switching off the power at the fuse box or circuit breaker. With the power disconnected, you can then proceed to drain the tank and remove any combustible materials from the area. By taking these simple precautions, you can help to ensure a safe and successful repair job.

Turn off the gas supply to the water heater by turning off the main valve

A water heater is a household appliance that most people use on a daily basis. However, many people do not know how to properly maintain their water heater. One important step in maintaining a water heater is to turn off the gas supply when the appliance is not in use. This can be done by turning off the main valve. Gas leaks can be dangerous, and turning off the gas supply will help to prevent them.

Additionally, it is important to check the water heater regularly for any signs of damage or leaks. By following these simple steps, you can help to keep your water heater in good working condition.

About The Author

Jules Perosky

Jules is a professional writer and blogger from the United Kingdom currently residing in Spain. He is an experienced interior designer, with a keen eye for aesthetic excellence. Jules has been writing about home design and lifestyle for more than 4 years; he is passionate about all things related to home decor and loves to share his experiences through his blog.

See author's posts